Quoted this week - a special version of the Dorner 3200 series belt conveyor with magnets embedded into the conveyor frame.
There is not normally a magnetic option on the 3200 series conveyor belts, but a special application this week required one with 4 rows of permanent magnets.
Specification:
75XXX010
3200 Series CE end drive conveyor with V-guide belt tracking,
1219mm wide belt
1,801mm long
Output shaft in position A with low side profile and type 08 standard high friction belt with fused finger splice.
Conveyor is CE marked.
Includes recommended mounting brackets and return rollers.
• The conveyor will be constructed with 4 rows of standard strength permanent magnets, evenly spaced across the width
of the conveyor.
The magnetic section will be 4.3” from the drive end and 6.0” from the idler end of the conveyor.
Magnets are installed below the belt, within the bedplate structure.
Reference p/n: 320U480591A0108-9
32UBESA-2014
3200 Series CE standard load eDrive™ bottom mounting package for an end drive conveyor
Mounted in the A position, 20:14 pulley ratio.
English documentation.
62Z040ES423EN
3200 Series CE standard load 90° shaft eDrive™ variable speed VFD gearmotor
0.24 Hp (.18kW), 230/400 volt, 3 phase, 25-63 Hz, 35 RPM,
Providing a belt speed of 6.1 - 15 m/min.
62UV2121
CE Variable Speed Controller
230V, 1 phase, 50 Hz input
230VAC output, 4.2 amp, reversing.
Line and motor cord included.
Visit our special page for more information on magnetic belt conveyors.